Browsing by Subject "Software-Sensoren"

Now showing 1 - 1 of 1
  • Thumbnail Image
    Publication
    Development of software sensors for on-line monitoring of baker’s yeast fermentation process
    (2021) Yousefi-Darani, Abdolrahim; Hitzmann, Bernd
    Software sensors and bioprocess are well-established research areas which have much to offer each other. Under the perspective of the software sensors area, bioprocess can be considered as a broad application area with a growing number of complex and challenging tasks to be dealt with, whose solutions can contribute to achieving high productivity and high-quality products. Although throughout the past years in the field of software sensors and bioprocess, progress has been quick and with a high degree of success, there is still a lack of inexpensive and reliable sensors for on-line state and parameter estimation. Therefore, the primary objective of this research was to design an inexpensive measurement system for on-line monitoring of ethanol production during the backer’s yeast cultivation process. The measurement system is based on commercially available metal oxide semiconductor gas sensors. From the bioreactor headspace, samples are pumped past the gas sensors array for 10 s every five minutes and the voltage changes of the sensors are measured. The signals from the gas sensor array showed a high correlation with ethanol concentration during cultivation process. In order to predict ethanol concentrations from the data of the gas sensor array, a principal component regression (PCR) model was developed. For the calibration procedure no off-line sampling was used. Instead, a theoretical model of the process is applied to simulate the ethanol production at any given time. The simulated ethanol concentrations were used as reference data for calibrating the response of the gas sensor array. The obtained results indicate that the model-based calibrated gas sensor array is able to predict ethanol concentrations during the cultivation process with a high accuracy (root mean square error of calibration as well as the percentage error for the validation sets were below 0.2 gL-1 and 7 %, respectively). However the predicted values are only available every five minutes. Therefore, the following plan of the research goal was to implement an estimation method for continues prediction of ethanol as well as glucose, biomass and the growth rates. For this reason, two nonlinear extensions of the Kalman filter namely the extended Kalman filter (EKF) and the unscented Kalman filter (UKF) were implemented separately for state and parameter estimation. Both prediction methods were validated on three different cultivation with variability of the substrate concentrations. The obtained results showed that both estimation algorithms show satisfactory results with respect to estimation of concentrations of substrates 6 and biomass as well as the growth rate parameters during the cultivation. However, despite the easier implementation producer of the UKF, this method shows more accurate prediction results compared to the EKF prediction method. Another focus of this study was to design and implement an on-line monitoring and control system for the volume evaluation of dough pieces during the proofing process of bread making. For this reason, a software sensor based on image processing was designed and implemented for measuring the dough volume. The control system consists of a fuzzy logic controller which takes into account the estimated volume. The controller is designed to maintain the volume of the dough pieces similar to the volume expansion of a dough piece in standard conditions during the proofing process by manipulating the temperature of the proofing chamber. Dough pieces with different amounts of backer’s yeast added in the ingredients and in different temperature starting states were prepared and proofed with the supervision of the software sensor and the fuzzy controller. The controller was evaluated by means of performance criteria and the final volume of the dough samples. The obtained results indicate that the performance of the system is very satisfactory with respect to volume control and set point deviation of the dough pieces.