Browsing by Subject "LCA"

Now showing 1 - 4 of 4
  • Thumbnail Image
    Publication
    Life cycle assessment of biogas used for the provision of thermal household energy in developing countries
    (2011) Lansche, Jens; Schock, S.; Müller, Joachim
    The utilization of dried dung as fuel for household cooking stoves is very common in rural areas of developing countries. The objective of this study was to compare the environmental impacts for the provision of cooking heat from biogas with the utilization of dung cakes. For this purpose, the method of life cycle assessment was used for assessing the impact categories global warming potential, acidification potential, eutrophication potential and human toxicity potential. The results show that anaerobic digestion at household scale can contribute to the reduction of greenhouse gases (GHG?s) as well as several other emissions in rural areas.
  • Thumbnail Image
    Publication
    Life cycle assessment of perennial cultivation systems : advancing applicability and comprehensiveness
    (2021) Lask, Jan; Lewandowski, Iris
    Resource-efficient perennial cultivation systems are considered promising sources of sustainably produced biomass to meet the growing demand of a future European bioeconomy. They require fewer agricultural procedures than annual systems, contribute to an increase in soil carbon sequestration and can be productive on marginal land. In Europe, the C4 grass miscanthus is the most prominent and best researched perennial crop for lignocellulosic biomass production. Recently, wild plant mixtures (WPM) have been suggested as a more diverse alternative system. Perennial cultivation systems have already been the subject of multiple sustainability assessments, with life cycle assessment (LCA) being the method most commonly used. This method aims to provide a holistic depiction of the environmental performance of a system. However, two challenges are usually encountered. First, results of agricultural LCAs very much depend on site- and management-specific characteristics. Parameters such as biomass yield, quantity of fertiliser applied and carbon sequestered can vary considerably, impairing the applicability of the method. Second, most of these studies focus on greenhouse gas emissions only. Land use impacts on biodiversity are commonly neglected, casting doubt on the comprehensiveness that LCA is trying to achieve. This thesis aims to advance the applicability and comprehensiveness of LCA of perennial cultivation systems. For this purpose, it focuses on three aspects relevant to the assessment of such systems, each of which was addressed by a dedicated research question: 1) How can the conducting and application of LCAs of perennial cultivations systems be simplified? 2) Which methodological approaches are best suited for the consideration of carbon sequestration and storage in LCAs of perennial cultivation systems? 3) How can land use impacts of perennial cultivation systems on biodiversity best be incorporated into the LCA framework? These questions were answered by applying the LCA method to perennial cultivation systems in three case studies, using specific approaches for the inclusion of sensitivity analysis and the evaluation of carbon sequestration and storage. In addition, information on the biodiversity impacts of perennial crop cultivation was collated by means of a meta-analysis which compared species richness and abundance in annual and perennial crop cultivation systems. Due to the variability of agricultural systems, the life cycle inventory phase can be quite intricate. Thus, the conducting of an LCA can be substantially simplified by focusing on a few relevant inputs and outputs only. In this thesis a global sensitivity analysis was used to identify the most important inventory parameters in the greenhouse gas assessment of miscanthus cultivation: carbon sequestration, biomass yield, length of the cultivation period, nitrogen and potassium fertiliser application, and the distance over which the harvested biomass is transported. Focusing on these inventory parameters, a simplified model was developed. It allows farmers and SME active in miscanthus-based value chains easy access to customised LCA results. This thesis includes a detailed analysis of the relevance of carbon sequestration and storage in the sustainability assessment of perennial cultivation systems. It was found that the quantity and in particular the permanence of carbon sequestered through the cultivation of perennial crops are critical for their favourability in terms of global warming impacts. Two alternative methodological approaches for the quantification of carbon sequestered were tested within two of the case studies – a simple carbon model and an allometric approach. In addition, the handling of the uncertain permanence of the carbon storage was reflected upon. The approaches were compared with regard to their suitability for use by typical LCA practitioners. It was concluded that allometric models should be used for the quantification of carbon sequestered and the corresponding amount accounted for as delayed emissions. This combination provides a manageable approach for the accounting of benefits from carbon sequestration and storage, and also prevents their overestimation. Established impact assessment methods such as ReCiPe2016 suggest characterisation factors for the incorporation of land use impacts on biodiversity into LCA. These factors use relative species richness as an indicator and assume a higher species richness in perennial than annual cultivation systems. This thesis includes a critical review of these characterisation factors, drawing on the results of the meta-analysis comparison of species richness in annual arable crops and perennial rhizomatous grasses. The meta-study did not confirm a higher number of species in perennial rhizomatous grasses than in annual arable crops. It was concluded that LCA studies on perennial cultivation systems need to be cautious in their application of the land use characterisation factors suggested in present-day impact assessment methods. Criticisms of the approach include the application of one single characterisation factor for diverse perennial cultivation systems such as WPM and miscanthus and the sole focus on species richness. In future, LCA research should focus on context-specific adjustment options for land use characterisation factors to ensure an adequate representation of biodiversity impacts in agricultural LCAs. Finally, the current focus on species richness in biodiversity impact assessment needs to be reassessed.
  • Thumbnail Image
    Publication
    The potential of miscanthus as biogas feedstock
    (2020) Kiesel, Andreas; Lewandowski, Iris
    Of all renewable energy forms, biomass accounts for the by far largest proportion of gross inland energy consumption in Europe. As the biogas sector in particular can provide demand-driven electricity generation, energy storage and flexible utilization options including biofuels, it is likely to play an important role in future energy systems in future. In Germany, the largest biogas market in Europe, energy crops provide the highest proportion of biogas input substrates, with maize being the most dominant. The environmental impact of biogas production is mainly attributed to energy crop production, with the risks of maize cultivation being particularly criticized. Perennial biomass crops have the potential to reduce the environmental impact of the biogas sector and miscanthus is an especially promising candidate crop due to its high yields. However, preliminary observations have indicated that the green harvest of miscanthus necessary for biogas production leads to a strong yield depression in the subsequent year. The aim of this thesis was to determine and understand the mechanisms influencing the green-cut tolerance of miscanthus and to assess the potential of different green-harvest regimes for biogas production. Here, ‘green-cut tolerance’ is defined as the crop’s ability to regrow in the year after the green harvest is performed without yield depression. A further aim of this thesis was to investigate the environmental performance of miscanthus-based biogas production and to determine its energy efficiency compared to other utilization options. Field trials were conducted to assess the potential of miscanthus hybrids for biogas production, the green-cut tolerance of Miscanthus x giganteus (Mxg), and how both are influenced by management practices (harvest regime x nitrogen fertilization). A Life-Cycle Assessment was performed to evaluate the environmental impact of biogas production from perennial C4 grasses, including miscanthus, and to assess the optimization potential compared to the standard biogas crop maize. The suitability of miscanthus biomass was investigated for the utilization options bioethanol, biogas and combustion, and the energy efficiency of these was compared based on their net energy yield. The results revealed that Mxg harvested in October showed the highest average biomass yield, the highest methane yield (approx. 6000 m3 methane ha-1) of all harvest regimes, and a higher substrate-specific methane (SMY) yield than for biomass harvested after winter. An earlier green harvest (July, August) improved the SMY, but led to a sharp biomass and thus methane yield decline in the second year and was identified as unsuitable for Mxg. As increased nitrogen fertilization showed no effect on the yield in any of the harvest regimes, it can be disregarded as a management practice for improving green-cut tolerance. Instead, harvest date was found to have a strong influence on green-cut tolerance and sufficient time for relocation of carbohydrates needs to be allowed before a green cut is performed. This finding is crucial for the utilization of miscanthus biomass harvested green and also for the breeding of new varieties with improved green-cut tolerance. Breeding targets for optimized biogas varieties should include to increase the SMY and biomass yield and to widen the possible harvest window. Selecting genotypes that relocate carbohydrates to the rhizomes earlier would allow an earlier green harvest without yield decline the following year, but this may involve a trade-off with the SMY. The suitability of miscanthus for the utilization options assessed was found to be influenced by biomass composition, which in turn was affected by genotype and harvest date. Lignin content had a negative effect on biomass quality for biogas and bioethanol production and increased with later harvest dates. Hemicellulose had a positive effect on biomass quality for bioethanol production through the improvement of the saccharification potential. Low ash, potassium and chloride content enhanced biomass quality for combustion by increasing the ash melting temperatures and decreased with a delay in harvest to after winter. For the biogas and bioethanol utilization pathways, novel miscanthus varieties with low lignin content need to be developed, whereas for combustion varieties with a high lignin content are more favourable. The Life Cycle Assessment revealed that the use of miscanthus has a high potential to reduce the environmental impacts of biogas crop production and thus the biogas sector. Miscanthus had a more favourable performance than the annual biogas crop maize in each impact category considered and the highest reduction potential compared to the fossil reference in the impact categories climate change, fossil fuel depletion and marine eutrophication. The choice of biomass utilization pathway had a considerable effect on the energy yield per unit area, with combustion showing the overall highest energy yield potential for electricity production. However, for the combustion pathway, miscanthus is generally harvested after winter and this is accompanied by biomass yield losses of 35% compared to peak yield. In the biogas pathway, miscanthus can be harvested close to peak yield, leading to an only 10% lower energy yield than that of combustion. When considering the use of miscanthus for biofuel production, the highest area efficiency was found for the direct use of biomethane, followed by battery electric vehicles fuelled by electricity from biomass combustion, and the lowest for the direct use of bioethanol. However, the low conversion efficiency of bioethanol production did not consider energy generation from by-products. In this thesis it was determined that the green-cut tolerance of miscanthus is influenced by the carbohydrate relocation to the rhizomes and thus by harvest date. Miscanthus harvested in October shows a high potential as feedstock for biogas production due to its high yield and sufficient digestibility, can help improve the biogas sector’s environmental performance and contribute to an increase in greenhouse gas mitigation. The digestibility of miscanthus biomass for biogas production could be improved by breeding and selecting genotypes with low lignin contents and by applying suitable pretreatment methods. Increased digestibility could also help to overcome potential trade-offs between early carbohydrate relocation and SMY. The efficiency of biomass utilization greatly depends on the utilization option, with a high efficiency being identified for biomethane as a transportation fuel and for peak-load power generation. It was shown that miscanthus is a suitable crop for the provision of sustainably produced biomass as a feedstock for the growing European bioeconomy that provides additional ecosystem services, e.g. groundwater and surface water protection.
  • Thumbnail Image
    Publication
    Untersuchungen zur Aufbereitung und Umwandlung von Energiepflanzen in Biogas und Bioethanol
    (2008) Schumacher, Britt; Jungbluth, Thomas
    Due to finite fossil resources, one opportunity for the future is to increase the supply of energy out of renewable energy sources. One of many opportunities is the use of biomass, which offers plenty combinations of different kinds of biomass, paths of utilization and conversion techniques for a flexible adaptation to natural local and regional frameworks as well as the anthropogenic needs. For an efficient utilization of the limited arable land for the supply of bioenergy, there is a need of up-to-date and proof data about specific energy yields and yields per hectare. The aim of this investigation was to determine these data for the biogas and bioethanol sectors. Batch-tests were carried out in laboratory scaled digesters to investigate specific biogas and bioethanol yields. Additionally the testing of different techniques of pre-treatment for energy crops and their effects on the biogas yield and the progression of the formation of methane were focused. The conversion of maize silage and full ripe triticale into biogas and bioethanol was compared by an energy and environmental balance. The steam explosion technique was included. Pre-treatment The steam explosion pre-treatment of biomass increases the speed of formation of methane and partly increases the methane yields. The effects differ depending on the kind of biomass and the stage of ripening. Other techniques of pre-treatment like microwaving and cooking did not show significant or partly negative effects. A variation of parameters in the trial setup might be interesting. Besides the positive effects of the steam explosion technique there are some arguments like the additional costs of investment, the diminished concentration of nutrients respectively the increase of material flow against it. The additional energy consumption, mostly thermal energy, can be supplied from waste heat out of the combined heat and power plant (CHP). The screening and the production of technical enzymes for the efficient pre-degradation of raw materials containing high amounts of lignocellulose should be the subject of research and development in the future. The combination of biological (enzymatic), chemical, thermal and mechanical pre-treatment techniques need to be investigated with the focus on energy efficiency. Methane yields of energy crops and stillage A broad number of biogas tests had been carried out on various maize cultivars. The specific methane yields of the maize cultivars varied over the harvesting date differently. The cultivars with a low ripening number reached higher specific methane yields. The dominant factor for the energy yield per hectare was the dry matter yield, not the specific methane yield. In general it is recommended to use well adapted cultivars with high dry matter yields and a good ensilaging behaviour. The catch crops increased the methane yields per hectare just partly. But for reasons of soil conservation the cultivation is recommended. The nitrogen fertilizer had mostly a positive effect on the dry matter yields and the energy yields per hectare, respectively. Maize gained higher energy yields per hectare than switch grass. The utilization of stillage out of whole maize plants or triticale´s grain from the ethanol production as well as the utilization of by-products like straw in the biogas production could double the energy output per hectare compared to the simple ethanol production. Further options for the optimization of the biogas production under conditions of practice are digester systems well-adapted on the substrate, the use of multi step systems and the development of analytic methods in order to gain effective process control. Correlation between chemical components and measured methane yields The specific methane yields calculated out of the neutral detergents fibre, starch, sugar, raw proteins and its substrate-specific factors were very close to the experimentally determined yields of the maize cultivars for the four harvesting times. But the measured and calculated values showed no correlation. Whether the biogas tests can be replaced, by other methods or techniques of analysis of the components and the determination of additional components for the estimation of the potential of new cultivars, should be subject of further investigations. Bioethanol yields The energy yields on the conversion pathway bioethanol without using the by-products are lower than the yields via conversion into biogas, because the ethanol fermentation is limited on material that can be converted into sugar first. The advantage of the ethanol production is a fluid fuel as result of the process. Combining the ethanol production with a biogas plant, the by-products also can be used energetically and a gaseous energy carrier can be produced. There are high potentials for the bioprocess engineering, for instance in breeding of microorganisms for the degradation of lignocellulosic biomass or of C5-sugar. Furthermore a process optimization of water and energy input is recommended. Energy and environmental balance Biogas as well as bioethanol (combined with biogas) is able to reduce the consumption of non-renewable energy carrier and its emission under the investigated scenarios and the scoop set. A future task will be the development of differentiated and well-adapted concepts on the basis of a decision between (liquid) fuels or stationary supply of thermal and electrical energy out of biomass. The aim is an efficient use of the limited areas of arable land and forests for the supply with bioenergy carriers by a useful combination of biomass, paths of utilization and conversion technique depending on natural local and regional conditions as well as the anthropogenic needs.